How to ensure that coating of the workpiece is high quality？

1, The preservation of powder coatings should be stored in a cool and dry condition and stored in strict order.

2、工件喷涂前应彻底清除所有表面的油污、污染物，正确进行工件予处理。

2, Before spraying the workpiece, thoroughly remove all oil and contaminants on the surface, and correctly handle the workpiece.

3、压缩空气应无油、无水和干燥，经常检查油水分离器的工作状况。 

3, Compressed air should be oil-free, dry and dry, and check the working status of oil-water separator regularly.  

4、工件夹持件结构设计应合理，与接地传送部份保持良好的连接。工夹具应定期清洗，以保持良好的接地。

4, The structural design of the workpiece clamping device should be reasonable and maintain good connection with the ground transfer part. Fixture should be regularly cleaned to maintain good grounding.

5、正确选用最后涂层所需的粉末涂料

5. Correctly choose the powder coating required for the final coating.

6、烘箱的温控系统性能要稳定，应能确保固化涂层所需之条件。

6, The performance of the powder coating curing oven temperature control system should be stable, and the conditions needed to ensure the curing coating should be ensured.

7、供粉器、回收系统和喷柜应无污染，无混用其它粉料，否则将影响最后涂层的外观。

7. Powder supplier box , recycling systems and powder coating cabinets should be non-polluting and non-mixed with other powder materials, otherwise the appearance of the final coating will be affected.

8、经常检查予处理，固化炉的性能，检查所用粉末的物理性能。

8. Check the properties of the powder coating curing oven regularly and check the physical properties of the powder used.

9、回收粉末必须过筛，并按规定比例新粉混合使用。

9, The recovered powder must be sieved and mixed with the new powder according to the prescribed proportion.

10、在粉末涂料喷涂现场附近应避免出现硅微尘或油漆微尘，以免影响外观质量。

10. Silicon dust or paint dust should be avoided near the powder coating spraying site to avoid affecting the appearance quality. 

Contact

 

Alisa

Tel/Whatsapp/Wechat/Skype:+86 13363836725

Email：sales01@coating.equipment.com