Service
- Curing OvenCuring temperature, time and coating effect:The powder coating itself is only a semi-finished product. It only becomes the final product after being sprayed and cured. The consumer pays attention to the effect and quality after the coating is applied. That is to say, the use of powder coating is as important as the production of powder coatingIndustry Technical Documents March 15, 2019
- Spray Paint EquipmentSpray booth function and classification The most basic task of the spray booth is to remove the paint mist, paint dust, solvent, etc. from the spraying process.Industry Technical Documents March 15, 2019
- Hanna manual conveyor system features*Hanna manual conveyor system features:1. Based on customer demand, provide the corresponding optimal design2. Fine workmanship to ensure the stability of the conveyor track * How to design an optimal solution?1. Comprehensive analysis of customer cost budget and capacity requirements, select manualIndustry Technical Documents August 22, 2019
- Discussion on Factors Influencing the Flowability of Powder Coatings for Electrostatic Spraying of Aluminum ProfilesDiscussion on Factors Influencing the Flowability of Powder Coatings for Electrostatic Spraying of Aluminum ProfilesPowder coating is a type of coating that is dispersed and painted with air as a carrier. It is a typical "4E" (efficient, economic, ecological, and energy) product, which grows at a raIndustry Technical Documents July 06, 2020
- Causes and solutions of condensation in dust processing equipmentCauses and solutions of condensation in dust processing equipment 1. Dust processing equipment has air leakage We all know that the internal temperature of the dust processing equipment is very high when it is working, and if the machine leaks, it will enter part of the outside air inside it. When tAnalysis of Common Problems June 04, 2020
- Reasons For Poor Powder Curing In Powder CoatingConsidering from the powder coating, if the matching between the resin and the curing agent is unreasonable in the formulation design, for example, the reactivity selection of the resin or the selection of the type and amount of the curing agent is unreasonable; the mass percentage or the volume concentration of the filler is too large, etc. Will affect the physical and mechanical properties of the film.Analysis of Common Problems March 15, 2019
- Attention Matters In Powder Coating Spray BoothThe production of powder coating spray booth is the key process in the spraying production process. The key to the quality of the surface of the sprayed workpiece lies in the control of various process parameters during the spraying process. The amount of powder and atomized air are two key technical indicators.Analysis of Common Problems March 15, 2019
- Electrostatic Spray Gun Cleaning And Routine MaintenanceOne: cleaning of the electrostatic spray gun After use, the spray gun and its accessories should be cleaned immediately. Improper maintenance and cleaning will increase the incidence of spray gun failure.Analysis of Common Problems March 15, 2019
- Common Faults And Analysis During Electrostatic SprayingCommon faults and analysis during electrostatic spraying 1. Host gun insurance blown (1A) 1A gun insurance2.When the spray gun enters the water, the high-voltage static electricity is short-circuited, the system is in protection, the output voltage is very low, and the spray gun is fully dried, and the water source is checked and disposed to ensure that the compressed air is monotonous.Analysis of Common Problems March 15, 2019
- Analysis of common defects on the surface of electrostatic coating of powder coatingAbstract: This paper briefly introduces the coating defects that are easy to occur during the powder coating process of spin-on oil filters and diesel filters. The coating defects were analyzed and a solution was proposed. introduction Spin-on oil filters and diesel filters have the characteristAnalysis of Common Problems October 23, 2019