Industry News

• Brief Introduction About Plastic Product Spraying Process

  1. Annealing: Internal stress is easily formed during plastic molding, and the stress concentration is easy to crack after coating. Annealing or full-face treatment can be used to eliminate stress. The annealing treatment is to heat the ABS plastic molded part below the heat distortion temperature.

  Industry News December 27, 2018
• General technical conditions for surface coating of steel products

  This standard is mainly applicable to the surface coating of steel products. Where there is no special requirement in the contract documents, the surface coating of the products shall comply with the provisions of this standard.First, the surface treatment before paintingAll steel raw materials used

  Industry News January 02, 2019
• Frequent problems in metal phosphating treatment and countermeasures

  Asl metal phosphating is one of the common measures for metal surface treatment, but in the process of operation, metal phosphating is prone to defects and affect the treatment effect, then metal phosphating often has defects and solutions.1. The phosphating part returns to rust.Cause: The free acid

  Industry News January 04, 2019
• Two types powder coating booth

  PVC is Insulating and non-conductive material ，The electrostatic powder forms a light and thin layer on the surface of the material, which has a rebound effect on the electrostatic powder afterwards, effectively avoiding powder accumulation. easy to clean, save time and labor; the booth is contained

  Industry News May 25, 2020
• What is the difference between painting and powder coating? 99% of paint people don't know

  Painting and dusting are two completely different coating methods. Painting is the use of compressed air to disperse liquid paint (commonly known as paint dispersed into paint mist particles adhering to the surface of the object to be coated, while dusting is done by means of compressed air arch pow

  Industry News January 09, 2019
• The difference between bridge type oven and tunnel oven

  1.Bridge type curing oven. The bridge-type oven is set up. The bridge oven has a good thermal insulation effect because the hot air is on a high level and will not convection with the cold air outside the oven.And the operation cost is low. But more suitable for wide workpiece is not suitable for long workpiece.

  Industry News February 27, 2019
• Technical requirements for electrostatic powder coating

  First, the effect of coating ambient temperature and temperature on the film thickness. The powder spray amount is 170-200 g/min; the voltage is 70 KV, and the distance between the spray gun and the object to be coated is 20 cm. When the temperature is between 20 and 30 ° C and the humidity is between 60 and 80%.

  Industry News February 27, 2019
• Various Pretreatment Processing for Powder Coating Line

  Pretreatment methods& different

  Industry News February 28, 2019
• Pretreatment System

  Chromizing, Phosphating,Vitrification, Silane: Chromization Principle: chromate solution and metal reaction, produce chromization layer on the surface of the workpiece.Application: mainly for aluminum, magnesium and its alloyswhen dealing with steel, often matching used with phosphating.Function: in

  Industry News July 08, 2019
• Manual Color Change Steps For Filter Recovery Spray Booth

  The Hanna powder coating line manual quick color change solution will reduce production stagnation time and increase productivity. Color change time: 15 minutesAdvantages: EconomicalDisadvantages: Not suitable for multiple color changeHanna patent: Filter recovery unit quick disassemble is convenient for color change

  Industry News July 30, 2019