News
- Technical analysis of automobile powder coating waste gas treatmentOn the whole, the organic waste gas treatment method should be based on the following factors: the types of organic pollutants, the concentration level of organic pollutants, the exhaust temperature of the organic waste gas, the discharge flow of organic waste gas, the level of particulate emission, and the control level of the pollutants to be reached.Industry News June 12, 2018
- How to test the performance of an electrostatic powder coating machineIn order to cover up the defects of their own products, the manufacturers of electrostatic spray machines are trying to find the most easily sprayed workpiece to demonstrate the effect of electrostatic spraying when they try the machine to the customers (especially the customers who have just contacIndustry News June 14, 2018
- How to solve the problem of loss of light in powder coating process?Slove the problem of loss sight in the powdre coating process.Industry News June 06, 2018
- Causes and methods of shrinkage of coating after electrostatic powder coatingCauses and methods of shrinkage of coating after electrostatic powder coating.Industry News September 12, 2018
- Aluminum profile spraying equipment -- pretreatment systemAluminum profile spraying equipment -- pretreatment system 1, The advanced oil removal and demulsification technology is used to realize synchronous processing and synchronous utilization, so as to avoid the two pollution of the workpiece. So that the aluminum profile can get better quality and exteIndustry News September 13, 2018
- How should the spray gun equipment be maintained?Use of spray gunThe structure of the spray gun is simple and easy to use, but it must be used correctly. There are many factors that affect the use of the spray gun, such as painted objects, painting materials, and even seasons. The key to the use of the spray gun is: the control of the adjustment kIndustry News September 14, 2018
- powder coating production line development historyThe development of China's coating production line has gone through the development process from manual to production line to automatic production line. China's painting process can be simply summarized as: pre-treatment → spraying → drying or curing → three waste treatment. China's coating industryIndustry News September 19, 2018
- Analysis of Surface Shrinkage Defects in Spraying ProcessThe reason for the pinhole in the spray is related to the following points:1. The workpiece has a small amount of water or oil on the surface before spraying. When the temperature is solidified, the oil or water evaporates and vaporizes, leaving pinholes on the workpiece.2. If the pinholes are one pIndustry News September 20, 2018
- Countermeasures for Surface Shrinkage Defects in Spraying Process(1) high quality cold rolled sheet with thickness less than 1mmNo pinholes will appear after painting. If there is a crack, because there is air in the crack, coating solidification may cause coating interruption and discontinuity, that is, large pores;A porosity is caused by rust or dirt on the surIndustry News September 20, 2018
- Anti-skid plate with powder coating for extended service lifeNowadays, in order to ensure the safety of employees, many companies have installed anti-skid plates in workshops, passages, factories, etc. The anti-skid plates are widely used, but they are extremely corrosive. Therefore, in order to extend the service life of the anti-skid plates, manufacturers will produce anti-skid plates. Some special surface treatments are carried out, of which powder coating is one of the surface treatment techniques.Industry News September 21, 2018