Article List

• Common Faults And Analysis During Electrostatic Spraying

  Common faults and analysis during electrostatic spraying 1. Host gun insurance blown (1A) 1A gun insurance2.When the spray gun enters the water, the high-voltage static electricity is short-circuited, the system is in protection, the output voltage is very low, and the spray gun is fully dried, and the water source is checked and disposed to ensure that the compressed air is monotonous.

  Analysis of Common Problems March 15, 2019
• Analysis of common defects on the surface of electrostatic coating of powder coating

  Abstract: This paper briefly introduces the coating defects that are easy to occur during the powder coating process of spin-on oil filters and diesel filters. The coating defects were analyzed and a solution was proposed. introduction Spin-on oil filters and diesel filters have the characterist

  Analysis of Common Problems October 23, 2019
• How to control the thickness of electrostatic powder coating

  How to control the thickness of electrostatic powder coatingThe sprayed profiles have various colors and are deeply loved by customers, but due to the complexity of the cross-sectional shape of aluminum profiles, it has brought certain difficulties to spray production and coating thickness inspectio

  Analysis of Common Problems June 02, 2020
• Reasons and precautions of phosphating and rusting in pretreatment of powder spraying equipment

  Reasons and precautions of phosphating and rusting in pretreatment of powder spraying equipmentPowder spraying equipment assembly line is generally composed of pre-processing equipment, powder spraying equipment, drying tunnel and chain, and electronic control equipment.The pretreatment electrophore

  Analysis of Common Problems June 05, 2020
• Three Stages in The Curing Process of Powder Coatings

  Three important stages for good powder coating process.+86 13363836725

  Case Application November 24, 2018
• Different fuels are used for curing furnace

  The advantage of the curing furnace to choose coal as fuel is low cost. But few countries use it because of the pollution.

  Case Application May 18, 2018
• Metal Door Frame Powder Coating Booth Equipment

  With the development of science and technology, social progress and the improvement of people's living standard, some luxury goods also gradually entered ordinary people's home, decoration is becoming more and more luxurious, some interior doors, glass doors will also install metal frame, in order to look beautiful,manufacturers usually surface powder coating treatment will be done, we will according to the size of the metal frame to design a plan for you, after signing the contract, we will complete the production, installation, and debugging of the one-stop service. We have 30 years of production experience in the production of metal door frame powder coating equipment. We have received high praise from customers both at home and abroad.Any inquiry is welcomed.

  Case Application February 07, 2018
• Steel Screen Spray Powder Coating Line

  1. Complete solve the problem of workpiece powder grooves on the dead angle, groove with powder. 2. Ensure that products without off color, don't fall off. 3. Ensure no powder spillover, fast color change.

  Case Application February 07, 2018
• Basic Skills of Resin Powder Electrostatic Spraying

  Tel/Wechat/Whatsapp:+86 13363836725

  Case Application November 22, 2018
• How to ensure that coating of the workpiece is high quality？

  High quality powder coating skills.

  Case Application October 27, 2018