Powder coating is an efficient and environmentally friendly coating process, and the powder coating curing process is its key step. Through heating and curing, the powder coating melts and hardens into a film, which directly affects the quality and performance of the coating. Therefore, choosing a suitable powder coating curing oven is critically important. This article provides a brief guide on how to choose the right curing oven for your needs.

Electrostatic spraying equipment high-temperature curing requires reasonable control of temperature and insulation timeHigh temperature curing for electrostatic spraying equipment is an important process in the spraying process, for the production process is of great significance, the next we introd

The color difference is simply the difference in color. After the high temperature curing of the workpiece of the electrostatic spray equipment, the color of the surface is different, which is called "color difference".

High quality powder coating skills.

The curing oven is one of the indispensable equipments in the powder coating production line. The function of the curing furnace determines the quality of the produced workpiece.

Our Automatic Electrostatic Powder Spraying Line includes: 1. Electrostatic Powder Coating Machine 2. Powder Coating Booth, Powder Spray Room, Multi-function Spray Room, Fast Automatic Color Change Powder Spraying Room, Electrostatic Powder Spraying Gun, Reciprocator, PLC Contral System 3. Pretreatment Equipment 4. Powder Recovery Equipment, Large Cyclone Powder Recovery System 5. Curing Oven, Hot Air Furnace, Biological Granule Combustion Machine, Gas Burner, Electric Heating Oven 6. Powder Coating System Transport Components, Automatic Elevating Equipment, Chain Suspension Conveying Equipment

Electrostatic Powder Spraying - Causes and Solutions for Uneven Coating Thickness. Cause: 1. The rough and bad pre-treatment of workpiece. 2. The curing time is too long or the temperature of curing oven is too high. 3. There are volatile gases in the furnace. 4. The proportion of recycled powder is too large. 5. Two different types of powder mix. 6. Poor quality of powder. Solution: 1. Select the appropriate pretreatment process. 2. Adjust the appropriate curing conditions. 3. Clean the oven. 4. After the recycled powder is filtered, it should be mixed with fresh powder, preferably less than 30%. 5. Thoroughly clean the dusting system before powder change. 6. Replace the good quality powder.

Selection of Heating Mode of Curing Oven (Heating Energy).The curing heating system is an important part of the powder spraying production line.