The electrostatic powder coating line, as one of the most common types of coating equipment, brings a lot of convenience to our work, but any mechanical operation has certain potential dangers. The relevant knowledge is very important, let us understand what should be noted below! 1, first of all, a

It is said that electrostatic spray is better, where is it better? Below Hanna Technology to analyze for everyone! !First, electrostatic spray molding has excellent film properties: as long as the powder coating is directly sprayed onto the surface of the pre-treated MDF sheet, after baking, a coati

Our factory successfully developed a double line design of the full automatic powder coating production line – – Power And Free Overhead Conveyor, which effectively improves work efficiency, saves raw materials, and occupy less area than the other powder coating production line, solves the problem of the small size of the factory.

Spray paint and powder coating (plastic) are generally called spray, the following explains the difference between spray paint and powder coating.1, Paint selection 1) Spray paint, paint containing fluorocarbon paint, acrylic paint, epoxy paint, polyurethane paint 2) Powder coating (plastic), the coating used is powder coating, commonly known as plastic powder.

Electrostatic Powder Spraying Process Can Improve the Utilization of Coating Powder

There are many factors affecting electrostatic powder coating, such as equipment factors and operating factors. However, the main factors are powder conductivity, powder particle size, spray voltage, spray distance (between gun and workpiece), and supply pressure.1. Powder Conductivity: The volume o

Reciprocators use a variety of electronics to control both stroke and speed. In these machines, the mechanical linkage between the motor and guns is fixed; therefore, speed and stroke control must be adjusted electrically. These adjustments are sometimes made at the control panel or at the units itself.

How to improve Aluminum profile powdered rate?

The development of China's coating production line has gone through the development process from manual to production line to automatic production line. China's painting process can be simply summarized as: pre-treatment → spraying → drying or curing → three waste treatment. China's coating industry

On the whole, the organic waste gas treatment method should be based on the following factors: the types of organic pollutants, the concentration level of organic pollutants, the exhaust temperature of the organic waste gas, the discharge flow of organic waste gas, the level of particulate emission, and the control level of the pollutants to be reached.