In practice, Aluminium profile coatings can develop linear or lattice cracks that resemble dry riverbeds, a phenomenon known as "large cracks". Large cracks" are usually caused by insufficient solvent when the coating film is melted during the baking process. This phenomenon is aggravated by the fol
Nowadays, our technological development has become very rapid, even the coating line equipment used in the coating line industry has also made a new breakthrough, and the air spraying machine is a new type of powder coating production line equipment, many decorators are very fond of using it to pain
Electrostatic spraying equipment should not be exposed to rain or humidity and should be kept away from flammable gases and liquids.The user should regularly check cleaning and maintenance and clean the powder supply system once a week to ensure smooth operation. When changing powder, the control po
Traditional liquid spraying and manual spraying methods are associated with high paint waste, serious environmental pollution, cleaning difficulties, low productivity, poor color, and unstable quality. Electrostatic spray painting is the solution to these problems. It is the same principle as electr
Causes of blistering and loss of light in powder coating system spraying and how to deal with it. Causes 1. The surface of the object to be coated is wet or there is acid, salt, salt, and other substances. 2. Water mixed with paint and thinners. 3. The surface of the object to be coa
Ash cleaning methods. 1, Gas cleaning: gas cleaning is with the help of high-pressure gas or external atmosphere blowing back the filter bag of the spray paint room to remove the accumulated ash on the filter bag. Gas cleaning includes pulse blowing cleaning, reverse blowing air cleaning, and reve
An automated powder coating system is the hardware of coating quality, but even the best and most advanced automated powder coating system is still useless if it is not properly managed. Keeping the automated powder coating system in the good technical condition is one of the necessary conditions to
1. Design level The urgent need for improvement in the design level is quite obvious, mainly because many companies do not invest enough in this area, which stems from a lack of awareness. As a result, the flow of advanced electrostatic powder coating booths into the Chinese market has been much
1. Based on customer needs, provide the corresponding optimal design2. Fine workmanship, comprehensive analysis of customer cost budget and capacity requirements.3. Comprehensive analysis of workpiece weight, size, shape and other factors, design the best size.4, Excellent durability and reliability
Chain conveyor system: The rail can be divided into 150 rails ≤ 30KG, 250 rails ≤ 50KG (single point lifting)1,The drive unit in our high-end conveyor system uses a drive with a torque limiter. When the conveyor goes wrong, it can automatically stop. After the malfunction is removed, it can be resta